 |  |  |  |  |  |
Lubrication Systems
and Supplies
Singel Line Resistance
Lubricator
SYSTEMS LINKS
Centralized lubrication systems are design to provide exact metered
amounts of fresh lubrication, at the proper intervals, to the desired
locations on your machinery.
pressure oil lubrication systems which consist of four basic elements.
1.) PUMPS - manual, air, or motor driven.
2.) METERING UNITS - orifices of various sizes designed to create flow
resistance to each bearing point.
3.) DISTRIBUTION NETWORK - hose & tubing plus various junctions and
connectors.
4.) MONITORING DEVICES - pressure gauge, low oil level switch, pressure
switch.
| APPLICATION |
CALCULATED OIL REQUIRED IN cc PER HOUR |
| BALL BEARING |
.10 X bearing diameter x number of rows |
| PLAIN BEARING |
.15 x bearing shaft diameter x bearing length |
| FLAT SLIDES |
.04 x (slide length + length of travel) x slide width |
| CYLINDRICAL |
.15 x (slide length + length of travel) x slide dia. |
| BALL SLIDES |
.03 x slide length x number of rows |
| CAMS |
.08 x surface area |
| GEARS |
.30 x gear pitch diameter x face width |
| CHAINS |
.05 x length of chain x width |
sizes in inches. Use this guide
only with equipment
manfacturer recommendations.
Calculated values should be
adjusted to suit environmental
conditions. Call or fax us with
your requirements.
TYPE F
has a flow rate and feed
direction marked on each fitting.
Do not attempt to adjust or
repair.
The main difference is that the meter unit uses a check valve
to prevent oil drain back between lubricating cycles. Therefore,
Meter Units are used in one shot or cyclic type lubricating
systems. Control Units are used in continuous type lubrication
systems.
TYPE C
| FLOW RATE |
FLOW VALUE |
SYSTEM TYPE |
OIL DISCHARGE DRIP RATE |
| 5/0 |
0.3 |
CONTINUOUS LOSS |
EXTRA,EXTRA SLOW |
| 4/0 |
0.6 |
CONTINUOUS LOSS |
EXTRA SLOW |
| 3/0 |
1.2 |
CONTINUOUS LOSS/ CYCLIC |
SLOW |
| 00 |
2.5 |
CONTINUOUS LOSS/CYCLIC |
MEDIUM SLOW |
| 1 |
5.0 |
CONTINUOUS RECIRCULATING/ CYCLIC |
MEDIUM |
| 2 |
10 |
CONTINUOUS RECIRCULATING/ CYCLIC |
MEDIUM |
| 3 |
20 |
CONTINUOUS RECIRCULATING/ CYCLIC |
MEDIUM FAST |
| 4 |
40 |
CONTINUOUS RECIRCULATING/ CYCLIC |
FAST |
| 5 |
80 |
CONTINUOUS RECIRCULATING/ CYCLIC |
EXTRA FAST |
| 6 |
160 |
CONTINUOUS RECIRCULATING/ CYCLIC |
EXTRA,EXTRA FAST |
